Remove the connector and disassemble the removable parts in order.

 

2. Fix the cable end and nail it on the shaft plate. The end extends out 200mm-300mm, and the end is inclined downward into an Angle of 30°-45° with the horizontal direction.

 

3. Use a hand saw or an electrician's knife to strip off a cable sheath about 45mm long. The cross section should be kept straight.

 

4 with sealant adhesive (87 or 703 glue) over the surface of the sheath and conductor junction (connector end cover can cover part of the) evenly daub after a circle, after the connector end cover (pressure locked loop), gaskets, seals sequence set on the cable, connect the connector in the outer conductor spiral direction set rotation is installed on the get rid of the outer conductor sheathed, close to the cable sheath end.

 

Use copper brush to clean the remaining sheath powder and copper scraps on the cable head.

 

6. About 2mm from the end face of the connecting sleeve, use special metal scissors to cut off the extra wrinkled outer conductor of the copper pipe. The outer conductor of the wrinkled copper pipe is flared and flanged outwards with sharp-nosed pliers, hammer and other appropriate tools to gently tap it to make it flat against the end face of the outer shell. Note that flanging should be even and round.

 

Remove sharp corners and burr with water mouth pliers, file, emery cloth and other tools.

 

8 smooth inner conductor of copper pipe, with a hand saw close to the fixed outer conductor saw off the outer conductor of the insulation strip and the inner conductor, with a file to repair the inner conductor (wrinkles) copper pipe end face, to edges and corners, with a tap tapping, depth should be compatible with the length of the thread of the inner guide component; For the inner conductor of wrinkled copper pipe, cut off the insulation strip extending from the outer conductor with water mouth pliers, and cut off the inner conductor of appropriate length with special metal scissors.

 

Screw the inner conductor assembly to the inner conductor (wrinkled) copper tube. The inner conductor of smooth copper pipe should be tightened with kesi pliers; For the inner conductor of wrinkled copper pipe, the thread connected with the inner conductor on the inner conductor assembly should be screwed into the inner conductor about 2mm, and the inner conductor should be gently knocked with the appropriate tools such as needle nose pliers and hammer, and then the inner conductor assembly should be wrapped in the inner conductor. Threads connected to the inner conductor assembly are exposed. Flanging requires tight and firm contact with the inner conductor assembly.

 

10 to inner conductor component, inner and outer conductor fixed components, inner conductor component, outer shell connected in sequence, tight, installation is firm (normally inner conductor component, inner and outer conductor fixed components, inner conductor component, installation does not need to remove the outer shell, then just put the inner conductor component and outer shell inner conductor component and are connected to, Rotate the screwdriver rotating port and the outer housing on the inner conductor assembly respectively).

 

11. Close the sealing ring, gasket and rear end cover in turn, tighten the rear end cover and connecting sleeve with a wrench, and wipe away the excess sealant.

 

12. Insert the plug into the inner conductor assembly 13. Install the sealing ring and the protective cover of the connector, and connect and fix with the connecting fastener; Unscrew the inflatable nozzle protection nut on the outer shell to inflate the cable, and fill the dry gas, so that the air pressure reaches 0.05Mpa - 0.2Mpa, and the air pressure remains above 90% of the air pressure value after 24h.